Installation Instructions
INSTRUCTIONS FOR INSTALLING A SUMMIT MAX® ON AN ALPHA
For an older style Alpha (nuts securing the lift rams)
- Remove the black plastic caps, nuts and washers from each lift ram assembly.
- Spread legs of Shower and align the lower of the two holes onto the lift ram shaft.
- Lean Drive Shower forward, remove bolt and washer from bearing cap.
- Place spacer (provided) over that hole.
- Insert bolt (provided) through the top mounting tab, through the spacer and screw the bolt into the bearing cap until snug.
- Install nuts onto lift ram assembly. DO NOT re-install washers. Tighten nuts and bolt to 30 ft./ lbs.
For the newer style Alpha (retainer clips securing the lift rams).
- Remove the black plastic caps, retainer clips and washers from each lift ram assembly.
- Spread legs of Shower and align the lower of the two holes onto the lift ram shaft.
- Lean Drive Shower forward, remove bolt and washer from bearing cap.
- Place spacer (provided) over that hole.
- Insert bolt (provided) through the top mounting tab, through the spacer and screw the bolt into the bearing cap until snug.
- Install retainer clips onto lift ram assembly. DO NOT re-install washers. Tighten bolt to 30 ft. / lbs.
INSTRUCTIONS FOR INSTALLING A HALO MAX® ON A BRAVO
- Remove black plastic caps, nuts and washers from each lift ram assembly.
- Spread legs of Shower, align holes in the brackets over the lift ram shaft. Replace nuts and caps.
- Lean Drive Shower forward and remove bolt and washer from bearing cap.
- Place spacer (provided) over that hole.
- Insert bolt (provided) through the top mounting tab, through the spacer and screw the bolt into the bearing cap until snug.
- Install nuts onto lift ram assemble. DO NOT re-install washers. Tighten nuts and bolt to 30 ft. / lbs.
Additional step for installing a Halo© on a drive with Latham or Imco steering that attaches to the “Back Inspection Cap”
To remove the top left stud from the drive, use a 3/8”-24 nut as a jam nut.
Tighten the two nuts together so that you can place a socket over the jam nut and onto the original nut. Loosen both nuts at the same time.
For questions or more information, please visit our website: driveshowers.com or we can be reached by phone at (480) 724-8164.
Instructions written by Simrek Corporation®.